JIANDA GREENHOUSE

Sep 04, 2022

Leave a message


Greenhouses, also known as greenhouses, mainly include glass greenhouses, plastic greenhouses, etc. The greenhouse structure should be sealed and insulated, but it should be easy to ventilate and cool down. Modern greenhouses have equipment to control temperature, humidity, lighting and other conditions, and use computers to automatically control the creation of plants. The best environmental conditions, let's introduce the construction method of the greenhouse


1. Leveling the land and setting out the line


According to the designed plan of the solar greenhouse, Zhipan determined the azimuth angle, determined the four corners of the greenhouse, installed piles at the four corners of the greenhouse, and then determined the position of the gable and the back wall.



2. Buried columns, erected roof trusses


According to the drawings, determine the position of each column and mark it with lime. Dig a 30-40 cm deep pit, use stones as pillar feet to prevent the pillar from sinking, and then install a digging truss on the rear pillar, with the head on the pillar, and the tail on the rear wall or the back auxiliary. On the column, put 3-4 purlins on the truss. The ridge purlins are connected at the truss, forming a straight line, and the other purlins are placed in a staggered manner. Some greenhouses only use uprights to support the purlins


3.cover film


There are two or three sheets of film in the greenhouse. When two sheets are used, their widths are 3 meters and 5 meters respectively, and when three sheets are used, their widths are 2 A, 4 meters, and 2 meters respectively. First roll back the film with a width of 3 meters or 2 meters, glue it with adhesive or iron it into a tube with a width of 5~6 cm, install a mud dragon rope, and fix the 3-meter-wide film at a distance of 2.5 meters from the ground. 2 meters wide and fixed at a distance of 1.5 m from the ground.


The film is first rolled into a roll, and the soil is filled into the cold-proof ditch while covering and tightening. Nylon ropes are to be taut, along with the film, and buried in the ground at the gables of the greenhouse. One or two sheets of film above are also rolled into rolls, one end is buried under the gable, and then spread out to the other end, and at the end, it is buried close to the gable. There are two ways to fix the end of the film close to the rear roof. One is to directly fix it on the ridge purlin with bamboo pieces and iron nails; Buckle on the rear roof. The width of the roof that can be buckled is about 0.5-1 meters, the more the better, and it is compacted with grass mud. This method has a better effect on improving the thermal insulation performance for the rear roof without waste film.


  film greenhouse

greenhouse

Send Inquiry